Post by kellysuemcclurgHi there,
I've followed your instructions to replace my asus keyboard but have
trouble with the connector part. I can't figure out how to remove the
connector from the computer. Also, my new board doesn't have the
plastic connector on it, just the flat ribbon cable. How do I attach
the bare ribbon cable to the plastic connector?
Well, I've never looked inside an Asus like that but I'll bet
you have what's called a ZIF connector. Look carefully at the top and
sides of the motherboard connector. You'll see a little door or flap
on the top OR two little knobs on the sides. VERY VERY CAREFULLY with
a NOT-SHARP PLASTIC tool or your fingernails (if you're a girl, lol, never
saw a guy with ones that were sharp enough ;-) lift that little door or push
the little knobs out (pop them out a bit). They're very delicate and don't
move much so be careful. Now slide the cable into the slot moving the latches
revealed and push the door down or the latches back.